Comentários do leitor

Do LED lights burn out?

por Fannie Dullo (2019-08-18)

Do LED lights burn out?
I know regular light bulbs burn out, and so do CFLs. but do LED lights burn out too? And do they provide the same level of light throughout their life, or fade like incandescent lights do?
Answer from Green Energy Efficient Homes
LED lights do burn out, but at least in theory they should last far longer than incandescent or fluorescent lights. All lights are rated in terms of the average hours they can be left on before the bulb burns out. While the cheapest incandescent bulbs are rated around 500 hours, and better ones around 800-1,000 hours (and in many locations, standard incandescent light bulbs are not even available for sale any more), fluorescent lights are typically rated at 8,000 hours or ten times longer.
LED retail store lighting. den led gia phuc bookmax
LED house lights meanwhile are supposed to last up to 100,000 hours, although the claims on product packaging are typically much lower, in the 25,000 to 50,000 range. I’m not sure if that is because manufacturers are hedging their bets, or if it’s that there are major quality problems that are bringing down the average, but still, even assuming a typical life of 25,000 hours, your LED lights would last you about 34 years if you use them an average of 2 hours a day. Even if you leave them on 24 hours a day, they should in theory last you almost three years!

One other consideration when considering how fast LED lights burn out is that an LED light bulb is made up of a number of individual Light Emitting Diodes. An individual LED may well last 100,000 hours, but it only takes one of those diodes failing before the bulb can be considered to no longer be working properly.

Compact fluorescent lights are typically rated at 8,000 hours but I have seen CFLs burn out much faster than that. One factor that leads to faster burnout of CFLs is their use in ceiling fixtures. CFLs are not ideally suited to ceiling fixtures, and tend to burn out faster there, for two reasons. First, they are meant to be positioned vertically, with the screw-on base either directly below or above the spiral coils of the bulb. In most ceiling fixtures they are positioned horizontally. Second,their life is shorted by heat, and an enclosed ceiling fixture will allow the heat to build up faster. The other thing I have noticed recently is that as prices have fallen in the last couple of yeras, we have seen a decrease in quality – you get what you pay for. I encourage you to always keep the receipts for any lights you buy – whether fluorescent, LED, or incandescent. If your incandescent or CFL or LED lights burn out well before their expected lifetime, you should take them back and demand a refund. The quality of newer bulb technologies will only improve if people fight back against cheap but poor quality products.

retail store lighting LED lights gia phuc

LED lights do burn out, but as I explain in my main LED house lights article, they typically start to fade long before that. In fact LED lights can dip down to less than 80% of their original brightness within 20,000 hours; the drop-off rate may be part of the reason manufacturers are toning down their claims of bulb life. I would submit that in almost every application, LED lights will fade to the point that they are no longer suited to their lighting task, and will be replaced for that reason before the burn out.

One bright point here is that LED lights are much less prone to wear and tear from frequent switching on and off, than are fluorescent lights, so if you do turn off lights whenever you leave a room (even if you might return very soon after), you’ll save energy while not damaging the lights.
All but one of your questions seem to point to one conclusion. The wiring in your house is somewhat antiquated. You more than likely are sharing more than one nominal ground on two or more circuits, or even common grounds with nominal. Your AC lines should each have their own separate common, the round hole on your outlet or circuit, or common, the large slit. The small slit carries the actual electricity. A long time ago, about around the inception of alternating current, it was common practice to connect grounds together. Another words; two or more circuits were tied together before the main breaker box or fuse box. This can lead to ground loops: weird anomalies such as lights staying on beyond being switched off and premature light failure. As for location in proximity of water : it all depends on the components that are connected to the LEDs. Another words is the fixture rated for that sort of application. Consult a qualified electrician.
I installed 10 new LED replacements for halogen down lighter spots 14 months ago in new luminaries. Each one has 15 LEDs and all but one are on the same circuit lighting our kitchen. The other one is on the under-cupboard lights circuit illuminating a dark corner and we often leave these lights on for a few ours at a time. So they’ve been used more than the main circuit.
LED shop lights, online led store
Now, the one LED on the under-cupboard lighting circuit has suddenly gone really dull. It’s probably outputting about 15% of its original illumination. I can see that one of its 15 LEDs is dead though the others are OK but dim. I wonder if I can expect the remaining bulbs to go soon as well.One bad bulb does not mean the entire batch are bad, but it does give you an inkling about the quality control of the manufacturer. There are many LED bulb manufacturers out there and the quality runs the full range.

I originally installed a no-name LED bulb in my dining room and they worked well but the lighting level was far below what was advertised on the bulb packaging. My wife complained constantly about not being able to see at the dining room table. Then I replaced them with Philips LED light bulbs, along with those in the kitchen (MR16 for both DR and kitchen) and the living room (PAR20). I went for natural daylight color temperature and they have worked wonderfully. My wife didn’t even notice I’d replaced them until I asked her a week or so after installation if she thought the lighting was okay.

If you use a dimmer switch, you need to replace it with one compatible with the particular LEDs you’re using. It’s possible that extended use of an incompatible dimmer switch can damage the LED bulbs.
Best LED Light Brands
Finally remember that the boast of 100,000 hours of bulb life is a best case scenario. On the other hand 14 months is an awfully short time for an LED light to burn out – even if it were on 24 hours a day you’ve barely hit the 10,000 hour mark. You might try contacting the manufacturer by their 800 number and complain – often they will send you a replacement to keep you happy.